Vanilla Klipper
Status¶
The Rinkhals vanilla-klipper app has been retired from the app store, and a replacement app is being worked on. Until it's available, there is no vanilla Klipper app from Rinkhals.
K3 and KS1 Support¶
Vanilla Klipper works on KS1 and K3 printers, but it needs a current klipper base and some driver additions. Without them, you may run into startup errors (e.g., Error Code 22 on the printer display).
For KS1/K3 vanilla-klipper builds, this community repository contains the necessary klipper base and driver patches:
Ported Drivers¶
The following drivers have been ported from Go to Python and are available in the dev branch:
- lis2dw12: lis2dw12.py (ported from extras_lis2dw12.go)
- cs1237: cs1237.py (ported from cs1237.go)
- probe_ks1: probe_ks1.py
Development branch: https://github.com/Kobra-S1/klipper-kobra-s1/tree/Kobra-S1-Dev
leviQ3 Driver¶
There is no leviQ3 port available, as this is closed-source IP of Anycubic. However, probing is still possible using the probe_ks1 driver, which supports generic Klipper nozzle probing.
Tunneled Klipper for SBCs¶
An alternative Rinkhals APP build is available that allows running vanilla Klipper on SBCs like the Raspberry Pi 4/5. This utilizes a Rinkhals "tunnel" app which tunnels the serial MCU communication between the printer and RPi via OTG USB Serial Gadget mode.
More information: https://github.com/Kobra-S1/vanilla-klipper-swu/blob/main/tunneled-klipper.md